Table of Contents
Advertisement
English
Installation
Belt clip
A belt clip is included, which can be fitted on the back of the handset. The belt clip
enables the hand unit to be attached to a belt, waistband or similar. On either side of
the handset, there are indents for the clips to clasp onto. To attach the clip, press it
into place over the back of the handset.
Wall mounting
The base unit can be wall mounted. Use two screws horizontally mounted 50 mm
apart. The screws should fit into the two 'keyholes' on the back of the base unit.
The base unit can also be attached to the standard Australian wall plate by using the
included bracket. Attach the bracket by inserting the locators into the "keyholes" on
the back of the base unit and pushing the spring clips into the holes on the underside
of the unit. The base unit can then be attached to the wall plate.
Battery
The telephone is supplied with environmentally friendly nickel metal hydride (NiMH)
batteries – 2 x AAA 1.2V. As with all batteries, performance may degrade over time;
should you notice that the standby time has reduced considerably or there are signs of
leakage, the batteries should be replaced.
Fully-charged batteries will last for approx 100 hours in standby or 10 hours call time.
These operation times apply at normal room temperature.
Full battery capacity will be achieved once the batteries have been charged 4-5 times,
completely discharged batteries will take about 10 hours to fully recharge.
Please note that the battery charge indicator in the handset display will flash while the
handset is on the base unit and will stop when the battery is fully charged.
The base unit has an automatic charging mechanism that prevents the batteries from
being overcharged or damaged by prolonged charging. It is better for handsets to be
charged every other night, rather than after each call.
Please note!
To ensure and maintain good charging of the handset batteries we recommend that the base and
handset charge contacts are cleaned regularly, ie monthly, with a pencil eraser and/or soft dry cloth. The
recharging system used in this model may result in the handset and the batteries heating up. This is
normal and will not harm the equipment.
When the telephone is installed for the first time, the batteries must be charged for 24 hours before
using the telephone. Use original batteries only. The guarantee does not cover any damage caused by
incorrect use of batteries. Please dispose of any batteries in a responsible and environmentally friendly
manner.
6
www.doro.com
Advertisement
Table of Contents
