Table of Contents
Advertisement
English
Installation
Belt clip
A belt clip is included, which can be fitted on the back of the handset. The belt
clip enables the hand unit to be attached to a belt, waistband or similar. On
either side of the handset, there are indents for the clips to clasp onto. To attach
the clip, press it into place over the back of the handset.
Wall mounting
The base unit can be wall mounted. Use two screws horizontally mounted 50
mm apart. The screws should fit into the two 'keyholes' on the back of the base
unit.
The base unit can also be attached to the standard Australian wall plate by
using the included bracket. Attach the bracket by inserting the locators into the
"keyholes" on the back of the base unit and pushing the spring clips into the
holes on the underside of the unit. The base unit can then be attached to the
wall plate.
Battery
The telephone is supplied with environmentally friendly nickel metal hydride
(NiMH) batteries – 2 x AAA 1.2V. As with all batteries, performance may
degrade over time; should you notice that the standby time has reduced
considerably or there are signs of leakage, the batteries should be replaced.
Fully-charged batteries will last for approximately 120 hours in standby or 10
hours call time. These operation times apply at normal room temperature.
Full battery capacity will be achieved once the batteries have been charged 4-5
times, completely discharged batteries will take about 10 hours to fully recharge.
Please note that the battery indicator in the handset display will alternate while
charging and will stop when the battery is fully charged.
The base unit has an automatic charging mechanism that prevents the batteries
from being overcharged or damaged by prolonged charging.
Please note!
To ensure and maintain good charging of the handset batteries we recommend that the base
and handset charge contacts are cleaned regularly, ie monthly, with a pencil eraser and/or soft
dry cloth. The recharging system used in this model may result in the handset and the batteries
heating up. This is normal and will not harm the equipment.
When the telephone is installed for the first time, the batteries must be charged for 24 hours
before using the telephone. Use original batteries only. The guarantee does not cover any
damage caused by incorrect use of batteries. Please dispose of any batteries in a responsible and
environmentally friendly manner.
www.doro.com
9
Advertisement
Table of Contents
