Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Doro 855 SIM
Summary of Contents for Doro 855 SIM
- Page 1 Manual doro 850 colour/855SIM...
- Page 3 English and key lock 1 New Message and Ring indicator 7 Disconnect and on/off 2 Left menu button/OK 8 Right menu button/erase/redial 3 Talk button/hands free function 9 Scroll button and ringer on/off 5 Recall...
-
Page 4: Table Of Contents
Transferring calls between Messages handsets ......35 Conference ......35 SMS messages ....16 Caller Identification..... 20 Other Handset Set Troubleshooting in general . 36 Specific Absorption Rate Handset ringer ....22 (SAR) ........37 Key tone......22 Guarantee......37 www.doro.com... -
Page 5: Installation
Do not place the base unit close to other electrical equipment such as TV sets, computer screens, telecom equipment, fans etc. This will minimise the risk of interference. Do not place the base unit in areas where it will be exposed to direct sunlight or other major heat sources. www.doro.com... -
Page 6: Belt Clip
When the telephone is installed for the first time, the batteries must be charged for 24 hours before using the telephone. Use original batteries only. The guarantee does not cover any damage caused by incorrect use of batteries. Please dispose of any batteris in a responsible and environmantally friendly manner. www.doro.com... -
Page 7: Battery Charge Indicator
If the handset is carried to far from the base unit during a call, the sound quality will deteriorate and a warning tone will be heard. Unless the handset is moved closer to the base unit within a few seconds the call will be cut off. www.doro.com... -
Page 8: Headset
Base Set. Press OK. 3. Scroll using to Date/Time. Press OK. 4. Enter the date using the handset keypad (DD.MM.YY). Press OK. 5. Enter the time (24 hour) using the handset keypad (HH:MM). 6. Press OK to save. www.doro.com... -
Page 9: The Display
Press 19 Key Lock Please note: To conserve battery power the display will be darken after approximately 20 seconds while on a call and when placing the handset on the base unit. To briefly illuminate the display, press < , www.doro.com... -
Page 10: Operation
Temporary silent mode If you do not wish to answer a call press Mute while the handset is ringing, this will temporarily turn the handset ringer off. On the next incoming call, the handset will ring as usual. www.doro.com... -
Page 11: Volume Control
, listen for the dial tone, then press 2. Please note that some networks require only the button to be pressed, contact your network operator for more services information. If this product is connected to a business PBX system, press the recall button followed by the extension number to transfer a call. www.doro.com... -
Page 12: Paging
The signal will stop automatically after a while or if the button on the handset is pressed. The page can also be cancelled by pressing on the base unit again. www.doro.com... -
Page 13: Menu
Message* SMS and caller ID (CID) new calls. Handset Set Settings for ringer, language, registering etc. Base Set Settings for date/time, call barring etc. INT Call Internal (Intercom) call. *Only functions in certain countries and also require subscription. www.doro.com... -
Page 14: Phonebook
2. Scroll through the entries in the phone book using . To perform a quick- search press the corresponding number button one or more times for the first letter (refer to the table on the previous page). 3. Press the displayed telephone number will now be dialled. www.doro.com... - Page 15 6. Some SIM cards may require a PIN code to be entered. Press OK. 7. It may take several minutes for the details on the SIM card to be read, the SIM card can then be removed. * At this point you can also scroll and select: display number or memory status. www.doro.com...
-
Page 16: Messages
Press Read. 6. Once you have read your message press Back to read another message, alternatively press Option. 7. Alternatively press Option and select one of the following using Use (answer/forward) Delete Entry Delete List Copy to Phoneb. www.doro.com... - Page 17 Press OK. 4. Scroll using to the required message. Press Read. 5. Press Option. 6. Select either Delete Entry or Delete List using . Press OK. 7. If Delete List is selected press OK again to confirm. www.doro.com...
- Page 18 Send. Press OK. 10. The display will indicate if the SMS has been sent and or has failed. If no error message is shown, the message has been sent correctly. Stored and failed SMS messages are saved in the Outbox. www.doro.com...
- Page 19 The factory setting is ON. 1. Press Menu. 2. Scroll using to Message. Press OK. 3. Scroll using to SMS. Press OK. 4. Scroll using to Set First Ring. Press OK. 5. Select the required setting using 6. Press OK. www.doro.com...
-
Page 20: Caller Identification
Apart from showing telephone numbers, the display can also show: Date/time not set (see page 32). Unavailable It is an International call or a call from a PBX (no information received). Withheld no Blocked number. The call could also be from a PBX. www.doro.com... - Page 21 The factory setting is OFF(=Australia). 1. Press Menu. 2. Scroll using to Message. Press OK. 3. Scroll using to Caller List. Press OK. 4. Scroll using to NZ Caller-id. Press OK. 5. Select the required setting using 6. Press OK. www.doro.com...
-
Page 22: Handset Set
1. Press Menu. 2. Scroll using to Handset Set. Press OK. 3. Scroll using to Ringer Set. Press OK. 4. Scroll using to Key Beep. Press OK. 5. Select the required setting using . Press OK to save. www.doro.com... -
Page 23: Alarm Clock
1. Press Menu. 2. Scroll using to Handset Set. Press OK. 3. Scroll using to Alarm Clock. Press OK. 4. Scroll using to Alarm Cancel or Alarm Melody. Press OK. 5. Select the required setting using . Press OK. www.doro.com... -
Page 24: Contrast
Only used in installations with more than one base unit. 1. Press Menu. 2. Scroll using to Handset Set. Press OK. 3. Scroll using to Select Base: Press OK. 4. Select either a specific base unit number or Any Base using . Press OK to save. www.doro.com... -
Page 25: Handset Name
4. Scroll to the required setting using . Press OK to save. Country code (855 SIM only) Some SIM cards will insert either “+” or 00 in front of any international telephone number, for example 01527583800 may be stored as +441527583800. -
Page 26: Registering An Additional Handset
Resetting will return most functions to the original manufacturer default settings. Registrations are not affected. 1. Press Menu. 2. Scroll using to Handset Set. Press OK. 3. Scroll using to Default Set. Press OK. 4. Enter your current handset PIN code (0000 at default). 5. Press OK to confirm. www.doro.com... -
Page 27: Base Set
2. Scroll using to Base Set. Press OK. 3. Scroll using to Ring Priority. Press OK. 4. Scroll using to Ring Count. Press OK. 5. Select the preferred number of rings (1 to 9) using 6. Press OK to save. www.doro.com... -
Page 28: Call Barring (Call Block)
7. Select the required entry using . Press OK. 8. Enter the telephone number to be barred (up to 8 digits). 9. Press OK to save. To activate the Barred Number setting please refer to Call barring (call block). www.doro.com... -
Page 29: Alternate Network Routing (Anr)
8. Select either On or Off using < > 9. Press OK to save. Automatic network prefix using ANR If the dialling code to be replaced is left empty the telephone will dial all numbers with the added ANR prefix. www.doro.com... -
Page 30: Pbx Function
Base Set. Press OK. 3. Scroll using to Dial Set. Press OK. 4. Enter the base unit PIN code (0000 at default). 5. Scroll using to Recall Time. Press OK. 6. Scroll to the required setting using 7. Press OK to save. www.doro.com... -
Page 31: Emergency Numbers
3. Scroll using to Dial Set. Press OK. 4. Enter your current base unit PIN code (0000 at default). 5. Scroll using to Dialling Mode. Press OK. 6. Scroll to the required setting using . Press OK to save. www.doro.com... -
Page 32: Date And Time
2. Scroll using to Base Set. Press OK. 3. Scroll using to Base PIN. Press OK. 4. Enter the current PIN number (0000 at default). 5. Enter your new number using the handset keypad. 6. Enter your new number again. www.doro.com... -
Page 33: Reset Base Unit Defaults
Registrations are not affected by resetting. 1. Press Menu. 2. Scroll using to Base Set. Press OK. 3. Scroll using to Default Set. Press OK. 4. Enter your current base unit PIN code (0000 at default). 5. Press OK to confirm. www.doro.com... -
Page 34: Expanded System
Refer to the Registration chapter for more information. If you wish to use several handsets with one base unit, you should ensure that the base unit is centrally positioned to evenly distribute the base unit range among the handsets. www.doro.com... -
Page 35: Intercom Calls
5. To connect all three callers in a conference call press Conf. By pressing or C.End to disconnect one party, any one of the handsets can terminate the conference call allowing the other continue the conversation with the external caller. www.doro.com... -
Page 36: Other
If that phone works, then it is likely that the equipment is faulty. If the telephone still does not work, contact DORO or the place of purchase. Don’t forget the receipt or copy of the invoice will be required for guarantee purposes. -
Page 37: Specific Absorption Rate (Sar)
9AM - 5PM Monday-Friday excluding Bank Holidays. Alternatively, E-mail on: tech@doro-uk.com You can contact us in writing: Consumer Support Group, Doro UK Ltd., 22 Walkers Road, North Moons Moat, Redditch, Worcestershire, B98 9HE, (regarding any Spares or Technical query), or Telephoning (Spares only): 01527 584377 Web site: www.doro-uk.com... -
Page 38: Australia And New Zealand
(As a matter of precaution, we recommend disconnecting the telephone during a thunderstorm). This guarantee does not affect your statutory rights. AUSTRALIA NEW ZEALAND DORO Australia Pty Ltd Atlas Gentech (NZ) Limited PO Box 6760 Private Bag 14927 Baulkham Hills BC NSW 2153... - Page 39 If a charge for local calls is unacceptable, the “DIAL“ button should NOT be used for local calls. Only the 7 digits of the local number should be dialled from your telephone. DO NOT dial the area code digit or the “0“ prefix. www.doro.com...
- Page 44 English Version 1.0...
Need help?
Do you have a question about the 855 SIM and is the answer not in the manual?
Questions and answers