Handset Register - Doro DECT 160 User Manual

Register a New Handset or Base Unit
In order to enable the use of more than one handset a registration has to be
performed.
Every new handset must be registered in order to use a base unit. A maximum
number of 4 base units can be registered with each handset, and each base unit
can handle up to 6 handsets.
On registration the handset is allocated a handset number from 1-6.
Additional base units and handsets can be purchased from your local retailer.
See also page 22 for more information about EXPANDED SYSTEM.
1. Press the
seconds) until the
sound is heard. Registration mode will remain active for about 2 minutes.
2. Press MENU (on the handset).
3. Scroll to REGISTER. Press OK.
4. Scroll to REG. HANDSET. Press OK.
5. Select a base number for the base unit you wish to register by pressing the
corresponding number button 1-4 (Flashing numbers are available).
6. Enter the base unit PIN code (0000 as default).
7. The handset will now search for the base unit. The display will show
WAITING...
8. After a few seconds (no more than 90) unused handset numbers are
displayed. Select one of these by pressing the corresponding number button.
9. If the registration is successful the handset will return to standby mode. The
new handset number is shown on the right of the display.
Select Base Unit
You can decide which base unit you wish the handset to communicate with. You
can also set the hand unit to automatically select the base unit with the best
connection (AUTO).
1. Press MENU.
2. Scroll to REGISTER. Press OK.
3. Scroll to SELECT BASE. Press OK.
4. Select a base unit by pressing the corresponding number button (0=AUTO).
The selected number remains steady and the available alternatives will flash.
5. Press OK to store.
www.doro.com
DECT160-360_20010530.indd
Registration
on the base unit (refer to page 9) and hold it down (about 5
indicator on the base unit starts to flash and a beep
Q
18-19
English
19
2001-05-30, 11:29