Remote Control - Doro DECT 160 User Manual

Answering Machine (DECT 360)

Remote Control

This machine can be controlled remotely from any tone dialling telephone. To
use remote control, ring the answering machine and enter the remote code after
the outgoing message has been played. Once the code is accepted, several remote
control commands are available.
Remote Code
This code is needed in order to gain access to the remote control functions of
the answering machine. This code is set to 0000, but it has to be changed to
another four-digit code (0001-9999) in order for the remote control functions
to work.
1. Hold CODE (underneath the base unit) until a beep is heard.
2. Select each digit using <</>>. The display as well as the voice will help you
select the right digits.
3. Press CODE to store.
To check the current remote code, press CODE once.
Remote Control
1. Ring the answering machine.
2. Enter the remote code after the beep that follows the outgoing message.
If the code is accepted, you will hear two short beeps.
3. New messages will play back automatically.
4. Select other commands from the list on the next page.
5. To end the remote control session, hang up the phone.
Please note!
If the machine doesn't respond correctly to the remote control commands, try pressing the
touch-tone buttons for a longer or shorter time.
www.doro.com
DECT160-360_20010530.indd 28-29
English
29
2001-05-30, 11:30