Procedure To Disable Imobilizer Engine Block Through Throttle Twistgrip - Ducati SPORT TOURING ST3 Owner's Manual

Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it
open. The EOBD warning light turns off after 8 seconds.
2) Release the throttle as soon as the EOBD warning
light turns off.
3) EOBD pilot light will flash. Count a number of flashes
corresponding to the first figure of the code printed on
the CODE CARD, open full throttle and keep the position
for 2 seconds, then release. In this way the input of one
E
figure is acknowledged, EOBD pilot light comes on and
stays on for 4 seconds. Carry out the same procedure for
the following figures of the code. Failure to do so will
cause the EOBD pilot light to flash 20 times, then it will
stay on. This means that the procedure has been
aborted. It will be necessary to turn the key to OFF and
restart from point 1.
4) Repeat operations described in point 3 up to the last
figure of the code.
5) Release the throttle twistgrip, if the code is correct the
following two conditions may occur:
A) the EOBD warning light shall flash signalling that
engine block has been disabled. The warning light turns
off after 4 seconds or if engine revolutions go over the
limit value of 1000 rpm.
B) the IMMO light (3, fig. 5) flashes until engine rpm get
above 1000 rpm, or until engine is re-started.
26
6) If the code is NOT correct, the EOBD warning light and
the IMMO light stay on and it is then possible to repeat
the procedure, starting from point 2, as many times as
necessary (infinite).
Note
Should the throttle twistgrip be released before the
set time, the warning light turns on again. It is then
necessary to bring the key to OFF and restart the
procedure from point 1.