Console Management; Login In The Console Interface - Planet FGSW-2620VM User Manual

The chapter is for model
The PLANET FGSW-2620PVM is equipped with a RS-232 DB9 connector as default, however, the FGSW-2620VM doesn't.
But both of the two models support telnet management.

5.1 Login in the Console Interface

To configure the system via console mode, connect a serial cable to a COM port on a PC or notebook computer and to
RJ-45 type serial (console) port of the Managed Switch. The console port of the Managed Switch is DCE already, so that
you can connect the console port directly through PC without the need of Null Modem.
Please refer to chapter 3.5- Administration Console (FGSW-2620PVM / FGSW-2612PVM)
how to connect to the console interface of FGSW-2620PVM with HyperTerminal on Microsoft Windows platform.
Once the terminal has connected to the device, power on the FGSW-2620PVM / FGSW-2612PVM, the terminal will display
that it is running testing procedures.
Then, the following message asks the login password. The factory default password as following and the login screen in
Figure 5-1 appears.
Username: admin
Password: admin

5. CONSOLE MANAGEMENT

FGSW-2620PVM / FGSW-2612PVM
Figure 5-1: FGSW-2620PVM / FGSW2612PVM Console Login screen
User's Manual of FGSW-Series
only.
127
to get more information about