Operating For The First Time - Westinghouse WLE527WA User Manual

OPERATING FOR THE FIRST TIME

CHOOSING UTENSILS FOR ELECTRIC HOTPLATES
Refer to the diagram below.
GOOD BAD
 
(recessed base)
(recessed base)
CHOOSING UTENSILS FOR GAS HOTPLATES
Refer to the diagram below.
 
(undersize)
Do not use utensils which are too large or too small.
INSTALLATION AND SERVICE WARNING
WARNING WARNING
• Only an authorised person must install and service this
appliance (Certificate of Compliance to be retained).
• In order to avoid a hazard, the installation instructions
MUST be followed.
• In order to avoid the appliance tipping, the anti-tilt plate
MUST be installed.
• Appliances requiring connection to 230 – 240V
MUST be earthed.
• An authorised person should inspect this appliance
every 5 years.
• This appliance must NOT be installed on a base,
box or in a closed cupboard.
• If the electrical supply cord is damaged, a qualified person
MUST replace the cord to avoid a hazard or
void your warranty.
WARNING
WARNING
Surrounding kitchen cabinets MUST WITHSTAND 85°C.
BAD
BAD
 
(convex base) (undersize)
(convex base) (undersize)
1. Read all the Warning and Safety information.
2. Remove all internal boxes and bags from oven.
3. Clean out the oven interior with detergent and warm water
and polish with a soft cloth. DO NOT close oven door until
the oven is completely dry.

(oversize)
4. If you have purchased a model fitted with a 3 button
programmable timer, you must set the time of day before you
can operate your appliance.
• After the appliance has been electrically connected "12.00"
will be displayed and the"clock indicator" will flash.
• To set the time of day, press the – or + buttons. 5 seconds
after the last change, the "clock" indicator will disappear,
confirming the time has been set.
NOTE: The clock has a 24-hour display.
5. New appliances can have an odour during first
operation. It is recommended to 'run in' the oven before you
cook. Run the oven at 180°C for 2 hours and ensure that
the room is well ventilated.
6. Turn grill on maximum for 15 minutes with grill doors open
for separate grill models with 10mm of water in the bottom
of the grill dish.
7. If your appliance is fitted with solid hotplates, turn
heat setting to high for 3 minutes to fully harden the
hotplate coating.
BAD
BAD
 
(oversize) (moisture on hotplate)
(oversize) (moisture on hotplate)
TIPS & INFORMATION
BEFORE OPERATING FIRST TIME
TIPS & INFORMATION
SETTING THE TIME
END
+
MODE
BAD

(no utensil)
(no utensil)
5
OPERATING