Installation - Westinghouse WLE527WA User Manual

INSTALLATION

LOCATION
The appliance has been designed to fit a 550mm gap in kitchen
cabinetry. Make sure the top of the hotplate is at least 10mm
higher than the level of the bench top. The appliance must not
be installed in a corner. It must be installed at least 100mm from
the side wall.
100mm min.
to combustible
material
600mm min.
to combustible
material
540mm
910mm
WARNING
WARNING
In order to avoid accidental tipping of the appliance (for
example, by a child climbing onto the open oven door),
the anti tilt plate and stabilising bolt MUST be installed.
Position anti-tilt plate to the rear wall and 25mm from side of
cupboard. Securely fix anti-tilt plate to the floor with fasteners.
Adjust levelling feet on cooker as required.
20
INSTALLATION
500mm min.
1150mm
Anti-tilt plate
1 .25m electrical
service cord (if fitted)
620mm
Rear cover
25mm to side
of bracket
5mm clearance
Cooker Anti-tilt
width 540mm plate
Rear adjustable foot
STABILISING BOLT
Stability
bolt
Kick-panel
1. Remove oven door - to be done by qualified personnel only.
(Refer to procedure).
2. Remove screws from kick panel. To remove kick panel lift
kick panel upwards to release the two location tabs from
the holes in the bottom of the panel.
3. Position cooker into the ant-tilt plate and then mark the
position for the stability bolt hole on the floor.
4. Pull cooker out and drill the bolt hole, using a 6.5mm
masonry or wood drill bit. The bolt hole needs to be a minimum
of 30mm deep when fixing the oven to concrete.
5. Reposition cooker back into place and fit the stability
bolt through the slot and into the drilled hole.
6. If the cooker is placed on a base, measures must be
taken to prevent the appliance slipping from the base.
WARNING
WARNING
For your safety this cooker is designed to be moved out of
position by a qualified person only.
Front
adjustable
6.5mm ø drilled
feet
location hole
INSTALLATION INSTALLAT