Assembly - Gold's Gym GGCCBE8057.0 User Manual

ASSEMBLY

Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. By setting aside
plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the fol-
lowing information and instructions:
• Assembly requires two persons. Some steps may
require three persons.
• Because of its size, the weight bench should be
assembled in the location where it will be used.
Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
1.
Before beginning assembly, read the impor-
tant information in the box above. See the
PART IDENTIFICATION CHART on page 5
for help identifying small parts.
Orient the Rear Leg (2) so that the Transport
Wheel (46) is on the side shown. Attach the Rear
Leg to the Bench Frame (1) with two M10 x
100mm Screws (117) and two M10 Washers
(148). Do not tighten the Screws yet.
2. Orient the Seat Carriage (6) as shown, and slide it
onto the Bench Frame (1).
Tighten the Seat Knob (56) into the Seat Carriage
(6). Next, pull the Seat Knob, slide the Seat
Carriage to the desired position, and engage the
Seat Knob into one of the holes in the Bench
Frame (1).
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• In addition to the included tools, assembly
requires the following tools (not included):
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Some assembly steps also require a socket set
with an extension.
1
1
2
56
7
148
46
2
6
1
117