Gold's Gym GGCCBE8057.0 User Manual page 26

50. Wrap the Rear Cable (94) under a Small Pulley
(74). Attach the Small Pulley, a Small Cable Trap
(93), and two Half Pulley Guards (91) at the sec-
ond hole from either end of the two Pulley Plates
(92) with an M10 x 48mm Bolt (125) and an M10
Nylon Locknut (153). Make sure that the Cable
Trap and the Half Pulley Guards are oriented
as shown.
51. Attach the Rear Cable (94) inside the Weight
Carriage Frame (18) with an M10 x 55mm Bolt
(127), two M10 Washers (148), and an M10
Nylon Locknut (153).
52. Identify the Low Cable (80). Route the threaded
end of the Cable through the Foot Plate (15) and
the Center Upright (13).
Wrap the Low Cable (80) under a Large Pulley
(165). Attach the Large Pulley inside the Center
Upright (13) with an M10 x 93mm Bolt (129), two
M10 Washers (148), two M10 x 25mm Spacers
(169), and an M10 Nylon Locknut (153).
50
153
51
52
153
148
169
15
80
26
91
94
74
93
91
92
125
153
18
148
148
127
94
165
13
169
148
129