Setting The Dial Mode - BT IMAGE 370 User Manual

11 Setting the dial mode

Your Image 370 has two dialling modes:
and , it is pre-set to
PULSE
the correct setting for all direct lines and most
switchboards, however for some switchboards
it may need to be set to
SET UP
Press the button
• SET UP
.
SET RESOLUTION
Press the or button until the display
•
shows
USER SET-UP
Press the button; display shows
•
.
LINE SET-UP
Press the button; display shows
•
.
RING RESPONSE
Press the or button until the display
•
shows .
DIAL MODE
Press the button; display shows
•
Press the or button to change between
•
and .
TONE PULSE
When the setting you require is shown in the
•
display press the
new setting.
Press the button three times to return
• STOP
to standby mode.
No dialling tone when using
Is your Image 370 line cord plugged into the
phone socket? Make sure the speaker volume
is not set to the minimum (see page 27).
TONE
. This will be
TONE
.
PULSE
display shows
;
.
.
TONE
button to confirm the
button
The
T/P (T=TONE, P=PULSE)
selector on the underside of your
T P
Image 370 base unit must also be
switched to the setting you have selected on the
display. This will ensure that calls can still be
made during power failure.
During use your Image 370 may tinkle bells in
other telephones sharing the same line. This is
not a fault and we suggest that you do not contact
the helpline.
Setting up
17