Setting The Answer Mode - BT DF450 User Manual

Using your DF450

Setting the answer mode

Your DF450 will operate in one of four modes:
,
MANUAL RX PHONE/FAX RX
AUTOMATIC RX
To change the answer mode:
Press the
• RX MODE
shows the required mode.
Which mode is correct for you?
MANUAL RX
A telephone should be connected to your
DF450 when using this mode.
Incoming calls will ring the attached phone.
If a call is not answered after 7 rings, your
DF450 will automatically switch to fax reception
and answer the incoming call.
When the phone rings
Pick up the handset. If you hear fax tones,
•
press the
START
replace the handset. The fax will be received.
17
,
TAD/FAX RX
.
button until display
button on your DF450 and
PHONE FAX RX
A telephone should be connected to your
DF450 when using this mode.
or
Incoming calls will ring the attached phone.
When a call is received, the phone will ring
twice and, if the handset is not picked up,
your DF450 will take the call and check fo
fax tones.
If your DF450 hears fax tones, it will receive
•
the fax normally.
If it does not hear fax tones, your DF450
•
will beep to indicate an incoming phone call,
the display will show
Lift the handset in order to speak.
•
Your DF450 will beep for up to 20 seconds.
•
(to adjust the time see Additional Features,
page 25). If the handset is not lifted after this
time, your DF450 will assume it is a fax.
It will stay in fax reception mode for about 30
seconds or, if it is a fax call, until the fax has
been received.
If you pick up the phone within the first two
•
rings and you hear fax tones, press the
button, replace the handset and your
START
DF450 will receive the fax.
.
LIFT HANDSET