Setting The Dial Mode - BT IMAGE 350 User Manual

Setting up

11 Setting the dial mode

Your Image 350 has two dialling modes:
and , it is pre-set to
PULSE
the correct setting for all direct lines and most
switchboards, however for some switchboards
it may need to be set to
SET UP
Press the
• SET UP
SET RESOLUTION
Press the or
•
shows
USER SET-UP
Press the
•
LINE SET-UP
Press the
•
RING RESPONSE
Press the or
•
shows
DIAL MODE
Press the
•
.
DIAL MODE
Press the
•
Press the or
•
and
TONE PULSE
When the setting you require is shown in the
•
display press the
new setting.
Press the
• STOP
to standby mode.
16
. This will be
TONE
.
PULSE
button display shows
;
.
buttons until the display
.
button; display shows
.
button; display shows
.
buttons until the display
.
button; display shows
button; display shows
buttons to change between
.
button to confirm the
button four times to return
TONE T
switched to the setting you have selected on the
display. This will ensure that calls can still be
made during power failure.
During use your Image 350 may tinkle bells in
other telephones sharing the same line. This is
not a fault and we suggest that you do not contact
the helpline.
.
TONE
The
T/P (T=TONE, P=PULSE)
selector on the underside of your
P
Image 350 base unit must also be