Table of Contents
Advertisement
> Use the plug to insert the mains section
in the socket.
Removing power supply
> To remove the power supply, proceed
in reverse.
Note:
Remove the mains section if you are not
planning on using the Traffic Assist for a
long time.
Connecting to the cigarette
lighter
Note:
If the cigarette lighter has just been used
and is still warm, wait until this has
cooled down in its mounting.
Power supplies using a vehicle battery are
connected up as follows using the cable sup-
plied for the cigarette lighter.
> Hold the connector and push it, with-
out using excessive force, to the stop in
the relevant connecting socket on the
Traffic Assist or the docking station.
> Plug the plug adapter into the cigarette
lighter.
Note:
If the engine is switched off, using
the vehicle's power supply through the
cigarette lighter will slowly drain
the vehicle battery! Do not therefore op-
erate the Traffic Assist for extended peri-
ods with the engine off.
Unit bracket
The Traffic Assist can be attached directly
to the windscreen with the unit holder.
Note:
The Traffic Assist and unit bracket must
not be exposed to long periods of direct
sunlight. Temperatures inside the vehicle
of +70 C and higher may damage parts of
the bracket.
>>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
23
Advertisement
Table of Contents
