Removing Power Supply; Connecting To The Cigarette Lighter; Tmc Antenna - Becker Traffic Assist Z 200 Operating Instructions Manual

Table of Contents

Advertisement

> Use the plug to insert the mains section
in the socket.

Removing power supply

> To remove the power supply, proceed
in reverse.
Note:
Remove the mains section if you are not
planning on using the Traffic Assist for a
long time.
Connecting to the cigarette
lighter
Note:
If the cigarette lighter has just been used
and is still warm, wait until this has
cooled down in its mounting.
Power supplies using a vehicle battery are
connected up as follows using the cable sup-
plied for the cigarette lighter.
> Hold the USB socket at the corrugated
grip area and push it into the connect-
ing socket to the stop without employ-
ing excessive force.
> Plug the plug adapter into the cigarette
lighter.
Note:
If the engine is switched off, using
the vehicle's power supply through the
cigarette lighter will slowly drain
the vehicle battery! Do not therefore op-
erate the Traffic Assist for extended peri-
ods with the engine off.
GENERAL OPERATION

TMC antenna

The TMC antenna included in the acces-
sories is used to receive traffic announce-
ments.
> Push the connector on the TMC anten-
na into the socket without employing
excessive force.
Note:
The TMC antenna must be routed so
that your ability to drive the vehicle is not
impaired.
Headphones cannot be connected when
the TMC antenna is connected. Howe-
ver, traffic announcements can be recei-
ved when the headphones are connected.
>>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
23

Advertisement

Table of Contents
loading

Table of Contents