Power Supply; Using The Battery; Via The Public Mains Grid; Connecting Up To Power Supply - Becker TRAFFIC ASSIST PRO Operating Instructions Manual

Table of Contents

Advertisement

General operations

Power supply

Note:
First always switch off the Traffic Assist
Pro before connecting up or removing
the power supply.

Using the battery

The integral replaceable battery supplies
power to the unit. The rechargeable bat-
tery is maintenance-free and does not re-
quire any particular care
Note:
Please note that with a completely di-
scharged battery, the unit requires up to
one minute until it can be switched on
again.
20

Via the public mains grid

Danger of Death!
Make sure that your hands are not damp
and that the mains section is dry. Only
connect the mains section to a mains
supply with which such purposes are
permitted.

Connecting up to power supply

The mains charger is connected to the
public mains grid as follows:
Hold the connector at the corrugated
!
grip area and push it into the
connecting socket up to the stop
without employing excessive force.
Use the plug to insert the mains section
!
in the socket.
The power supply is now connected.

Removing power supply

!
To remove the power supply, proceed
in reverse.
Note:
Remove the mains section if you are not
planning on using the Traffic Assist Pro
for a long time.
Via the vehicle battery
(cigarette lighter socket)
Connect the power supply via the
vehicle battery and the car adapter
provided as follows:
!
Insert the connector on the car adapter
into the socket marked "DC 5V" on
the Traffic Assist Pro.
Note:
If the cigarette lighter has just been used
and is still warm, wait until this has
cooled down in its mounting.
Insert the adapter into the socket on
!
the vehicle.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRAFFIC ASSIST PRO and is the answer not in the manual?

Table of Contents