Power Supply; Using The Battery; Connecting To Socket; Connecting Up To Power Supply - Becker Highspeed II Operating Instructions Manual

General operations

Power supply

Note:
First always switch off the Traffic Assist
Highspeed II before connecting up or
removing the power supply.

Using the battery

The internal power supply is via the in-
tegrated rechargeable battery. The re-
chargeable battery is maintenance-free
and does not require any particular care.
Note:
Please note that with a completely di-
scharged battery, the unit requires up to
one minute until it can be switched on
again.
19

Connecting to socket

Danger of Death!
Make sure that your hands are not damp
and that the mains section is dry. Only
connect the mains section to a mains
supply with which such purposes are
permitted.

Connecting up to power supply

Connection to the public mains grid is
achieved using the optionally-available
mains power supply unit. Please proceed
as follows to connect to the mains:
Hold the USB connector at the corru-
!
gated grip area and push it into the
connecting socket to the stop without
employing excessive force.
5017
Use the plug to insert the mains section
!
in the socket.

Removing power supply

To remove the power supply, proceed
!
in reverse.
Note:
Remove the mains section if you are not
planning on using the Traffic Assist
Highspeed II for a long time.