Position Information (Toolbar) - Becker TRAFFIC ASSIST PRO Operating Instructions Manual

Block road
The driving directions
planned by the Traffic
Assist Pro may be hin-
dered by unanticipated
road blocks.
This function notifies
the system of the length
of a road block. Existing
road block lengths may
be selected. Once the
length has been entered,
the route is replanned
and new directions gi-
ven (only if driving
guidance is activated).
Interim desti-
Allows you to enter a in-
nation
terim destination (only
if driving guidance is
activated).
• See "Navigation
menu: Navigation"
on page 37.
Next destinati-
Indicates the next desti-
on
nation, if multiple desti-
nations have been ente-
red (only if driving
guidance is activated).
Mute mode
The voice prompt for
driving manoeuvres can
be activated or deactiva-
ted.
Settings
• See "Navigation
menu: Settings" on
page 48.
TMC
• See "Using TMC"
on page 57.
Status
• See "Navigation
menu: Status" on
page 55.
Navigational mode

Position information (toolbar)

You can call up the information window
if you require information on a particular
point on the map display. If information
has been stored, this window shows the
address of the particular point on the
map and offers a number of functions so
you can decide on your next step.
Press the following key on the toolbar
!
to stop the driving guidance and map
display temporarily.
6041
The map remains stationary. If a particu-
lar destination does not appear in the
map display, you can either expand the
map display or move the map using the
keys in the toolbar.
Press and hold down the required des-
!
tination in the map until a window
opens to allow you edit the destinati-
on.
65