Table of Contents
Advertisement
Using the Step Sequencer
Changing the Timing of Pattern Switching
1.
Perform steps 1 through 3 of the procedure
under "Changing the Solo1 Channel" on page
E-55.
br
2.
Use the
up (q) and down (w) to move the
item selection cursor (0) to "Pattern Change
Timing".
br
3.
Use the
minus (–) and plus (+) buttons to
select one of the pattern switching timings
described below.
Wait : Wait until the start of the next measure.
Real : Switch immediately, even if it is partway through a
measure.
Beat : Switch at the beginning of the beat.
• The pattern switching timing setting is saved as
Performance parameter.
Syncing Step Sequencer Playback with an
Arpeggio
See "To use the Arpeggio Function" on page E-40.
Changing the Step Sequencer
Tone
You can use the Synthesizer's mixer function to change the
Step Sequencer tone.
• Data assigned by the mixer to channels 8 through 16 is
saved as Step Sequencer data.
• Mixer parameters are applied to all pattern parameters.
• For details, see "Using the Mixer" on page E-78.
E-56
To sound a single part
(solo mode)
1
1.
Press
STEP SEQUENCER and then press
7
EDIT.
• This step is not necessary if you already pressed
EDIT and are already editing a step sequence.
bn
2.
Press
MIXER.
3.
Hold down the button (
buttons) that corresponds to the part you want
to solo.
• To cancel the solo setting, exit the Step Sequencer
Mode or display the Track On/Off screen (page E-57).
• For details about mixer operations, see "Using the
Mixer" on page E-78.
Editing a Sequence - Advanced
You can use the procedures in this section for advanced,
detailed editing of sequence parameters.
To perform advanced parameter editing
7
1.
Press
STEP SEQ.
2.
7
Press
EDIT.
3.
br
cursor (U, q, w, I) buttons to
Use the
move the item selection cursor (0) to the menu
item for the edits you want to perform.
7
4
9 to 16 note part
Mixer screen
Advertisement
Table of Contents
