Mixer Settings - Casio XW-G1 User Manual

Other Useful Functions

Mixer Settings

■ Part 01 through Part 16 Settings
Display
Part on/off. Turns each part on or off. This is the same parameter that is turned on and off by the
Part
1 to 16 buttons (page E-79).
Part tone. This is the tone of each part.
While this item is selected, you can select a tone using the same operation as that used in the Tone
Mode.
Tone
• A tone with DSP will have DSP next to the tone name on the display (page E-37).
Volume Part volume. This is the volume of each part.
Pan Part panning. Adjusts the left-right position of sound in the stereo field.
CoarseTune Part coarse tune. Shifts the pitch of notes by semitone units.
FineTune Part fine tune. Shifts the pitch of notes by cent units.
Part bend range. Specifies (in semitone units) the maximum change in pitch when the
BendRange
wheel is rotated.
DSP Line Part DSP line. Specifies whether DSP (page E-36) is applied to the notes of each part.
Rev Send Part reverb send. Controls how the reverb effect (page E-36) is applied to each part.
Cho Send Part chorus send. Controls how the chorus effect (page E-36) is applied to each part.
■ External Input Part Settings
Display
Part
Volume
Pan
Same as "Part 01 through Part 16 Settings" (page E-80).
DSP Line
Rev Send
Cho Send
Noise gate threshold. Reduces noise by cutting all input sound at a volume that is smaller than this
N.Thresh
setting value.
Noise gate release. Time that input sound is cut after its volume drops below the noise gate threshold
N.Release
value.
Auto level control. Automatically adjusts the input signal level. The greater the setting value, the stronger
Auto Level
the effect.
■ Master Settings
Display
Volume Master volume. Adjusts the volume of all the parts.
Pan Master panning. Adjusts the left-right position of sound in the stereo field of all the parts.
E-80
Description
Description
Description
Settings
4
Off, On
Part 01:
Solo Synth P000 to
PCM Drum U309
Part 02 to 16:
PCM Tone P100 to
PCM Drum U309
0 to 127
–64 to 0 to +63
–12 to 0 to +12
–99 to 0 to +99
bt
BENDER
–24 to 0 to +24
Off, On
0 to 127
0 to 127
Settings
0 to 127
0 to 127
Off, 1 to 3
Settings
0 to 127
–64 to 0 to +63