Table of Contents
Advertisement
8.
bp
Use the
dial or the
• The table below shows the contents of the parameter editing menu.
Menu Layer
1
2
Parameter >Ent
Max Step
Step Size
NoteLngth
Groove
Grv.Type
Velocity
Hold Pedal
9.
After you finish arpeggio parameter editing, save it as described below.
7
• Press
WRITE to display the screen for saving arpeggio data. Save the arpeggio by performing the same operation as
that for saving a user tone (page E-12).
• For information about deleting data you saved, see page E-83.
■ Saving Arpeggio Data on an External Device
• Memory card (page E-86)
• Computer (page E-92)
br
minus (–) and plus (+) buttons to change the parameter settings.
Description
Maximum step. Can be edited only by step type.
Step size. Specifies the note length between steps.
Note length. Specifies the length of the note that is sounded as
a percentage of the step size. (100% for the same length as
the original, 50% for half the original.)
Groove. Specifies the timing of the up beat step. (50% for
even. Larger values increase the length of the first half of the
note.)
Groove type. Specifies the note length when the Groove
setting is anything besides 50%.
Velocity. Specifies the velocity of an input arpeggio. Specifying
KeyOn inputs a velocity value in accordance with the degree
of key pressure applied.
Hold pedal. Specifies on/off switching for hold used by a pedal. On, Off
Sounding Arpeggios Automatically
Settings
1 to 16
2, 6,
, 7,
, 8
1 to 100%
10 to 90%
Norml: Plays back at the actual percentage of the
step length.
Short: Adjusts to a short step in accordance with the
step.
KeyOn, 1 to 127
E-43
Advertisement
Table of Contents
