To Configure Effect Settings - Casio XW-G1 User Manual

(1) Reverb
(2) Chorus
(3) Normal DSP
(4) Solo Synthesizer DSP
(5) Master Equalizer
* When a tone with DSP (tone that uses a particular DSP) that is not a Solo Synthesizer tone is selected. A tone with DSP will
have "DSP" next to its display name on the mixer screen (page E-78) or performance editing screen (page E-73).
■ Chorus and DSP Use Restrictions
Only one of the three effect types (Chorus, Normal DSP, Solo Synthesizer DSP) can be enabled at any time.
Under this condition:
Chorus Mode
• A tone other than the Song Sequencer is selected by
Zone Part 1, and the Chorus is selected by "Chorus/
DSP Select" (page E-38).
Normal DSP Mode
• A tone other than the Song Sequencer is selected by
Zone Part 1, and the DSP is selected by "Chorus/DSP
Select" (page E-38).
Solo Synthesizer Tone Mode
• Solo Synthesizer tone selected by Zone Part 1.

To configure effect settings

1. bn
Hold down EFFECT until the effect list top screen shown below appears.
bn
Adds reverberation to make it sound like you are playing in a room or in a hall.
Combines multiple layers of the same note to create a sound with more depth.
A collection of versatile Normal DSP effects help to enhance the sound of tones. For example,
distortion can be applied to an electric guitar sound to make it sound more powerful. There are 46
different Normal DSP types, and the most appropriate one for the selected tone is applied
*
automatically. A DSP can be edited and saved as a user DSP.
One of the elements that makes up a Solo Synthesizer tones. See "(7) Total Block" in the "Editable
Parameters for Solo Synthesizer Tone" on page E-21. There are six Solo Synthesizer DSP types.
When you edit a Solo Synthesizer DSP, it is saved as part of a Solo Synthesizer user tone. You
cannot save it as a user DSP.
Adjusts the frequency characteristics of the Synthesizer's notes. The Master Equalizer can be used
to adjust the frequency and gain of four frequency bands: low, mid1, mid2, and high.
This type of effect is valid:
(2) Chorus
(3) Normal DSP
(4) Solo Synthesizer DSP
Selecting and Creating Tones
And effects are applied to each
part like this:
Depends on the mixer chorus send
value (page E-80) and the selected
tone chorus send value (page E-29).
(3) is applied only to parts whose
mixer DSP line (page E-80) is on.
(4) is applied only to Zone Part 1 and
parts whose mixer DSP line is on.
E-37