Gilson 402 User Manual page 49

Operation - Standard Use
(ii)Press the command
button to aspirate AIR.
The command light is
steady and you see
alternately In Run
Screens 3a and 3b.
(iii) Put the tip of the
transfer-tubing into
the sample then press
the command button
to aspirate liquid. The
command light is
steady and you see
alternately In Run
Screens 4a and 4b.
(iv) Put the tip of the
transfer-tubing into a
recipient vessel then
press the command
button to dispense the
fraction, the command
light is steady. Repeat
for the other fractions.
The command light is
steady and you see
alternately In Run
Screens 5a and 5b.
(v)Put the tip into the
waste then press the
command button to
dispense the 'Extra
volume'. The com-
mand light is steady
and you see alter-
nately In Run Screens
6a and 6b.
M33/T 2: RINSE 1
means Method 33 Task 2, Rinse, first cycle.
(vi) Put the tip of the transfer-tubing into the waste
then press the command button to rinse. The
command light goes out while the tubing is
being rinsed. Then, you are returned to In-run
Screen 1 for the next sample. At his point you
may continue to cycle through In-run Screens 1 to
6, or end the run by pressing STOP, in which
case you see the Abort Screen.
In Run Screen (3a)
In Run Screen (4a)
In Run Screen (5a)
In Run Screen (6a)
In Run Screen (3b)
In Run Screen (4b)
In Run Screen (5b)
In Run Screen (6b)
Abort Screen
4
4-13