Inserting The Module - Gilson 402 User Manual

Installation
3-12

Inserting the Module

Do not try to force the module into position as this
may affect the alignment of the component parts.
You should proceed carefully as follows.
1) Tilt the top of the module inwards and carefully
insert the upper part of the module into the front
aperture. When the syringe drive motor is inside
the aperture, tilt the module into the upright
position.
2) Push the module into the aperture, making sure
that none of the cables become trapped between
the module and the edges of aperture. The module
rests on a rubber strip that dampens vibrations
and helps ensure the module is fitted correctly.
3) Secure the module in place at the top using the
two screws (provided).
4) Replace the cover by pulling the sides outwards
slightly and lowering the it over the 402. Insert
and tighten the four screws at the base of the 402
that secure the cover to the lower chassis. Do not
forget to reinstall the washers, which are designed
to ensure that the cover and chassis are con-
nected electrically.
5) Install the Tee-junction on the front of the
module using the two screws provided.
6) Install the syringe as described page 3-9.
7) Connect the hydraulic tubing according to pages
3-4 and 3-5.
8) Reconnect the power cord and switch the
instrument ON.
3