Appendix C: Top And Back Panels - Zoom X7N User Manual

Appendix C: Top and
Back Panels
The following table describes each light on the top panel.
Light Description
Power Lights when the X7N is plugged into a power source
and the Power button on the X7N rear panel is
pushed in.
DSL Blinks when the X7N is performing its startup
sequence. Stays on solid when the unit has synched
up with its ADSL connection.
Note: If the light fails to switch from blinking to
steady after a minute or two, check with your ADSL
provider that the ADSL connection is activated, or
refer to Appendix A: Troubleshooting Tips
page 70.
Internet Blinks when data is sent and received.
Ethernet Lights when the Ethernet port of the X7N is
plugged into the Ethernet port of a powered-up
[1-4]
device. Blinks when there is data activity.
WLAN Lights when the Wireless Local Area Network is
running and enabled. Blinks when data is sent.
The following table describes each item on the back panel.
Port Description
DSL Jack to connect the modem to the ADSL telephone
wall jack.
Ethernet LAN ports that can connect the unit to access points,
network hubs, or the Ethernet ports of a computer.
[1-4]
Power Port to connect the unit to the X7N's power cube.
RESET In the unlikely event that you need to reset the modem
to its system default settings (necessary if
communication link is lost), you can press the RESET
button for 7 seconds.
Appendix C:Top and Back Panels
on
X7N User Manual