Setting Up Security Using Mixed Wpa2 / Wpa Mode20 - Zoom X7N User Manual

WPA2/WPA mixed mode which lets you connect with devices
that support either standard. We recommend you use this setting
unless you want to use on your network a wireless device that only
supports WEP security. In the unlikely event that you need to use
WEP, skip to Setting Up Security Using WEP
Setting Up Security Using
Mixed WPA2 / WPA mode
WPA2 and WPA use a passphrase that you choose and enter on
the X7N and other wireless devices on the network (clients) to set
up security. To use Mixed WPA2 /WPA, all of the wireless devices
on your network must support either encryption method. If you
know that all your devices support the more secure WPA2 you can
select WPA2 instead of mixed WPA2/WPA.
1
To use WPA2/WPA mode, all clients that you plan to put on
the network need to support WPA2 or WPA. In the unlikely
event that one does not, skip to
WEP on page 21.
2
Open the Zoom Configuration Manager by typing the following
in your Web browser's address bar:
3
In the Enter Network Password dialog box, type the
following User Name and Password in lower case, then click
OK..
User Name: admin
Password: zoomadsl
(The User Name and Password entered here are not the same as
the user name and password that your Internet service provider
may have given you.)
4
Click Wireless on the left-side menu of the Configuration
Manager.
5
In the SSID (Wireless Network Name) field, assign a name
to your wireless network. This is the name that all your wireless
devices will connect to. You can leave the default name Zoom
if you wish.
6
Then click Security on the left-side menu and from the drop-
down menu for Select SSID, select the name you just assigned
in step 5.
Chapter 3:Setting Wireless Security
on page 21.
Setting Up Security Using
http://192.168.1.1
X7N User Manual