Rimage DL5200 User Manual page 18

5. If necessary, perform a front to back
alignment.
a. Turn the front to back alignment
screw until there is a 1/16" (1.5mm)
gap between the front edge of the
disc and the raised edge of the disc
retainer.
Tip: You can use the Torx T25
driver, or 5/32" Allen wrench, to
turn the front to back alignment
screw.
b. When the printer is aligned, rotate
the lead screw to raise the lift arm
up about 1.0" (2.5 cm).
6. Exit the diagnostic test.
a. Press and hold the operator button to exit diagnostic test 4. The disc is lifted up to the
top output tray and released.
b. Press the operator button fourteen times and hold on the last press to exit diagnostics.
c. Press the operator button one time to close the printer tray.
110768_E
Maintain the DLN5200/DL5200
Disc Retainer
Gap Distance
Lift Arm
Print
Pad
Lead
Screw
13