Rimage DL5200 User Manual page 17

Rimage DL5200/DLN5200 User Guide
c. Manually rotate the lead screw
counterclockwise to move the lift arm
down to the print pad.
3. Check the disc alignment.
To see if the disc is centered, observe
the gap between the edge of the disc and
the raised edges as shown by the
arrows.
If the disc requires side to side
alignment, continue to step 4.
If the disc requires front to back
alignment, continue to step 5.
4. If necessary, perform a side to side
alignment.
a. Loosen the two side to side
alignment screws.
b. Slide the printer until the side gaps
are equal.
Important! Slide the entire
printer, not the printer tray.
c. Tighten the two side to side
alignment screws.
12
Front to Back Alignment Screw
Side to Side Alignment Screws
Print Pad
Lead Screw
110768_E