Xerox D95 System Administration Manual page 29

2. Enable the EtherTalk port.
a) Select System Settings.
b) Select Connectivity & Network Setup.
c) Select Port Settings.
d) Select EtherTalk and then select Change Settings.
e) Select Port Status and select Change Settings.
f) Select Enable and then select Save.
3. If necessary, enter the IP Address.
4. Exit the System Administrator Mode.
5. After the machine is restarted, print out the Printer Settings List to confirm that the
EtherTalk port is enabled.
Note
Configure EtherTalk as necessary.
Configuration on the computer
The configuration procedure for the computer is to install the print driver.
Xerox ® D95/D110/D125/D136 Copier/Printer
System Administration Guide
Configuration
2-5