Starting And Stopping The Pump; Adjust And Save A Pump Speed; Operating The Pump At Preset Speeds - Pentair IntelliFloXF Installation And User Manual

8
Stopping and Starting the Pump
Starting the Pump
1. Be sure the pump is powered on and the green power LED is on.
2. Select one of the speed buttons, then press the Start/Stop button (LED on) to
start the pump. The pump will go into priming mode if priming feature is enabled.
Stopping the Pump
1. Press Start/Stop to stop the pump.
When servicing equipment (fi lters, heaters, chlorinators etc.), disconnect the
communication cable, and switch OFF circuit breaker to remove power from the pump.
Note: The pump can automatically restart if the communication cable is connected.
To Adjust and Save a Pump Speed
1. While the pump is running, press the Up or Down arrow to adjust to desired
speed setting.
2. Press and hold down a Speed Button for three (3) seconds to save speed to
the button or press Enter to save the speed.

Operating the Pump at Preset Speeds

The pump is programmed with four default speeds of 750, 1500, 2350 and 3110
RPM. Speed buttons 1-4 are for each of the preset speeds.
1. Be sure the pump is powered on and the green power LED is on.
2. Press the Speed button (1- 4) corresponding to the desired preset speed and
release quickly. The LED above the button will turn on.
3. Press Start/Stop. The pump will quickly change to the selected preset speed.
IntelliFloXF ™ and IntelliProXF
LED lit
Speed Speed
1 2
™ Variable Speed Pump Installation and User's Guide
Speed Speed
3 4