Grandstream Networks GXW40XX User Manual page 24

Via TFTP Server
Via HTTP or HTTPS Server
Firmware Server Path
Config Server Path
XML Config File Password
HTTP/HTTPS User Name
HTTP/HTTPS Password
Firmware File Prefix
Firmware File Postfix
Config File Prefix
Config File Postfix
Allow DHCP Option 66 to
override server
Automatic Upgrade
Authenticate Conf File
Grandstream Networks, Inc.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
This is the IP address of the configured TFTP server. If selected and it is non-zero
or not blank, the GXW40XX retrieves the new configuration file or new code image
from the specified TFTP server at boot time. After 5 attempts, the system will
timeout and then it will start the boot process using the existing code image in the
Flash memory. If a TFTP server is configured and a new code image is retrieved,
the new downloaded image is saved into the Flash memory.
Note: Do NOT interrupt the firmware upgrade process (especially the power
supply) as this will damage the
this process may take up to 15 or 20 minutes.
The URL for the HTTP server used for firmware upgrade and configuration via
HTTP.
Note: If Auto Upgrade is set to No, GXW40XX will only do HTTP download once at
boot up.
IP address or domain name of firmware server. That URL of the server that hosts the
firmware release. The default server is: fm.grandstream.com/gs
IP address or domain name of configuration server. The server hosts a copy of the
configuration file to be installed on the gateway. The default server is:
fm.grandstream.com/gs
The password used for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration file.
The user name for the HTTP/HTTPS server.
The password for the HTTP/HTTPS server.
Default is blank. If configured, GXW40XX will request firmware file with the prefix.
This setting is useful for Internet Telephone Service Providers. End users should
keep it blank.
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
If set to "Yes", configuration and upgrade server's information can be obtained using
DHCP option 66 from DHCP server. This option specifies the URL of the tftp server.
Note: If DHCP Option 66 is enabled, the gateway will attempt downloading a
configuration file from the server URL provided by DHCP, even though Config
Server Path is left blank.
Choose "Yes" to enable automatic upgrade and provisioning. When set to No,
GXW40XX will only do upgrade once at boot up.
When "Check every day" or "Check every week" is checked, user can specify "Hour
of the day (0-23)" or "Day of the week (0-6)". Default time is Monday 1AM.
There are three options to choose from: "Always check for New Firmware at Boot
up", "Check New Firmware only when F/W pre/suffix changes", and "Always Skip the
Firmware Check".
If set to Yes, configuration file is authenticated before being accepted. This protects
the configuration from unauthorized modifications.
GXW40XX User Manual
Firmware 1.0.4.2
device. Depending on the network environment
Last Updated: 06/2011
Page 24 of 38