Icom iF5062D Instruction Manual page 9

SCAN ADD/DEL (TAG)
➥ Push to add a channel to, or delete it from the current scan
list.
• When a channel is added to the current scan list, the display
briefly shows "SCAN ON." When a channel is deleted from the
current scan list, the display briefly shows "SCAN OFF." After
"SCAN ON" or "SCAN OFF" appears, the display briefly shows
the current scan list.
➥ You can add a channel to, or delete it from a scan list after
selecting the list.
1. Hold down for 1 second to display the currently selected
scan list, and then push [CH Up] or [CH Down] to select
a desired list.
2. Push this key to add a channel to, or delete it from the
selected list.
• When a channel is added to the selected scan list, the display
briefly shows "SCAN ON." When a channel is deleted from the
selected scan list, the display briefly shows "SCAN OFF."
3. Hold down this key for 1 second to exit the scan list
selection mode.
➥ Push this key while a scan is paused on a channel, other
than a primary or secondary channel, and then the channel
is deleted from the scan list.
• Depending on the setting, the deleted channel is added back to
the scan list after the scan is cancelled. (Nuisance Delete func-
tion)
PANEL DESCRIPTION
PRIORITY A, PRIORITY B
Push to select the Priority A or Priority B channel.
PRIORITY A (REWRITE), PRIORITY B (REWRITE)
➥ Push to select the Priority A or Priority B channel.
➥ Hold down for 1 second to assign the operating channel to
the Priority A or Priority B channel.
MEMORY CHANNELS 1, 2, 3, 4
Push to select memory channel 1, 2, 3 or 4.
MONITOR, MONITOR (AUDIBLE)
➥ Push to turn the CTCSS (DTCS) or 2/5-tone squelch mute
ON or OFF.
• Only during LMR (Land Mobile Radio) operation, push to
open any squelch, or deactivate any mute functions.
• Only during PMR (Private Mobile Radio) operation, push
to activate one or two of the following functions on each
channel (Depending on the pre-grogrammed settings):
- Hold down to unmute the channel ('Audible' mode).
- Push to mute the channel ('Inaudible' mode).
- After the communication is finished, push to send a 'reset code'
(5-tone) or a 'Clear Down' signal (BIIS).
NOTE: The 'Audible' (unmute) mode may automatically
return to the 'Inaudible' (mute) mode, after the pre-pro-
grammed time period.
➥ Depending on the pre-programmed settings, holding down
this key for 1 second cancels a scan.
1
1
4