Icom iF5062D Instruction Manual page 10

1
PANEL DESCRIPTION
■ Programmable function keys (Continued)
PUBLIC ADDRESS
Push to activate the PA (Public Address) function. When
this function is turned ON, the audio level can be separately
controlled from the transceiver by pushing [CH Up] or [CH
Down].
• This function can be used when external equipment, such as an
audio amplifier, speaker, etc. is connected.
• Push this key, then hold down [PTT] and speak into the micro-
phone.
RX SPEAKER
Push to turn the RX Speaker function ON or OFF.
When this function is turned ON, the received audio can be
heard through an external speaker.
• This function is useful when you are away from the transceiver.
• The audio output level is linked to the transceiver's volume control.
LIGHT
Push to turn the backlight ON for about 5 seconds, when the
Backlight function is set to "OFF" in the User Set mode.
LOCK
➥ Hold down this key until "LOCK ON" is displayed to elec-
tronically lock all programmable keys except the following:
[Moni], [Light], [Lock], [Call] (incl. Call A and Call B), [Emergency],
[Surveillance], [Lone Worker] and [OPT 1/2/3].
➥ When the Key Lock function is ON, hold down this key
until "LOCK OFF" is displayed to turn it OFF.
5
LONE WORKER
Push to turn the Lone Worker function ON or OFF.
• If the Lone Worker function is turned ON, and no operation occurs
during the pre-programmed time period, the Emergency function is
automatically turned ON.
HIGH/LOW
Push to select the transmit output power level temporarily or
permanently, depending on the pre-programmed settings.
• Ask your dealer for the output power level for each selection.
TONE/COLOUR CODE CH SELECT
➥ While in the analog mode, push to enter the continuous
tone selection mode. Then push [CH Up] or [CH Down] to
select the desired tone frequency/code setting. After se-
lecting, push this key again to store the setting.
➥ While in the digital mode, push to enter the colour code
selection mode. Then push [CH Up] or [CH Down] to se-
lect the desired colour code. After selecting, push this key
again to store the setting.
➥ While in the mixed (digital and analog) mode, push to enter
the continuous tone selection mode. Then push [CH Up] or
[CH Down] to select the desired tone frequency/code set-
ting. After selecting, push this key to store the setting. After
that, the colour code selection screen appears. Push [CH
Up] or [CH Down] to select the desired colour code. After
selecting, push this key again to store the setting.