Advertisement
PRE-INSTALLATION
Before proceeding with the installation of the screen, please read the installation and operations instructions thoroughly!
s
!
CAUTION! Do not cut wrapping paper or tape with knife or any sharp tool. Remove by
hand.
1. Carefully unpack the screen and remove the outer wrapping.
2. Always handle screen in upright position.
3. Remove the front cover of the screen from the back of the screen. Lift front cover up approximately 1/2" and pull
away from back of screen. See Figure 1.
4. Remove hex head screws that secure the metal shipping brackets to the wood board.
5. Remove the Phillips head screws that attach the screen case to the wood board.
6. Remove the metal shipping brackets from the back of the slat.
7 . There are two methods of mounting the screen, suspended from ceiling and wall mounted. See Figure 2.
NOTE: Allow 1/2" above screen (when mounted) for front cover of screen installation and removal.
8. Picture surface is centered in case. Case extends 7" beyond surface on either end. Do not attach anything to screen
slat on the bottom of the screen.
BACK OF
SCREEN
PICTURE SURFACE
FIGURE 1
HANGER BRACKET
HANGER
PIN
FRONT
COVER
SLAT
WALL MOUNTING
CEILING
ALLOW A MINIMUM OF
1-1/4" FROM CEILING
"V" BAR MOUNTED
TO THE WALL
WALL
"V" BAR
MOUNTED TO
THE BACK OF
THE CASE AT
THE FACTORY
FIGURE 2
2
CEILING MOUNTING
PICTURE
SURFACE
PLACE "D"
RINGS OVER
HOOKS WELL
SECURED IN
CEILING.
PICTURE
SURFACE
Advertisement
