Summary of Contents for Da-Lite DESIGNER DA-TAB ELECTROL
Page 1
POWER PRESENTATION PRODUCTS DA-LITE SCREEN COMPANY, INC. Instruction Book for 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 ® DESIGNER DA-TAB ELECTROL Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 Toll Free Fax: 877-325-4832 www.da-lite.com e-mail: info@da-lite.com...
PRE-INSTALLATION Before proceeding with the installation of the screen, please read the installation and operations instructions thoroughly! ▲ HANGER BRACKET CAUTION! Do not cut wrapping paper or tape with knife or any sharp tool. Remove by hand. 1. Carefully unpack the screen and remove the outer wrapping. HANGER 2.
Page 3
Turn the black limit switch screw counterclockwise to increase the amount of up travel. Run the screen up to test the stop position. If more travel is desired, lower the screen about one foot and adjust the limit switch again. Repeat until the desired position is set. DESIGNER DA-TAB ELECTROL ® INSTALLATION...
Page 4
Turn the red limit switch screw counterclockwise to increase the amount of up travel. Run the screen up to test the stop position. If more travel is desired, lower the screen about one foot and adjust the limit switch again. Repeat until the desired position is set. DESIGNER DA-TAB ELECTROL ® INSTALLATION...
TROUBLESHOOTING SYMPTOM CAUSE SOLUTION 1. Screen will not operate. (a) Incorrect line voltage. (a) Verify 115-125V (or 220-240V). If insufficient voltage, rewire Motor does not hum. incoming electric line. (b) Blown fuse. (b) Replace fuse. (c) Tripped circuit breaker. (c) Reset circuit breaker. (d) No power to operating switch (d) Check above.