Summary of Contents for Da-Lite ADVANTAGE DELUXE ELECTROL
Page 1
POWER PRESENTATION PRODUCTS DA-LITE SCREEN COMPANY, INC. Instruction Book for 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 ® ® ADVANTAGE DELUXE ELECTROL Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 Toll Free Fax: 877-325-4832 www.da-lite.com e-mail: info@da-lite.com...
IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3.
If the screen limit switch setting is changed in the up direction, the unit must be recalibrated. Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less drop of picture, proceed in the following manner: NOTE: Use a screw driver or 5/32"...
Page 4
MORE SCREEN DROP 1. Place operating switch in “down” position. 2. When the screen stops, turn the white “down” limit knob (Fig. 2) one-quarter turn counterclockwise. Test by raising picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained. ▲...
ADVANTAGE DELUXE ELECTROL INSTRUCTIONS SCB-100 CONTROL ® ® NOTE: Electrical connections on right side of case. POWER INPUT AND CONTROL BOARD ARE LOCATED ON RIGHT 120V WIRING DIAGRAM SIDE OF SCREEN HOUSING. BLACK (HOT) BLACK (HOT) TERMINAL BLOCK POWER INPUT GREEN (GROUND) GREEN...
Page 6
ADVANTAGE ® DELUXE ELECTROL ® INSTRUCTIONS SCB-200 CONTROL NOTE: Electrical connections on right side of case. POWER INPUT AND CONTROL BOARD ARE LOCATED ON RIGHT 120V WIRING DIAGRAM SIDE OF SCREEN HOUSING. BLACK (HOT) BLACK (HOT) POWER INPUT GREEN (GROUND) GREEN (GROUND) (UP)
Page 7
ADVANTAGE ® DELUXE ELECTROL ® INSTALLATION 7-1/4" 7-1/4" VARIABLE POSITION CASE LENGTH MOUNTING BRACKETS 6-1/8" FLAT BAR MOUNTING METHOD MOTOR END 9-1/4" ELECTRICAL JUNCTION BOX 6-1/8" (SUGGESTED) 3/8" THREADED ROD (NOT INCLUDED) ATTACHED TO MOUNTING BRACKET 7-1/4" FINISHED CEILING SELF-TRIMMING FLANGE 8-3/4"...
TROUBLESHOOTING SYMPTOM CAUSE SOLUTION If screen is not responding properly and SCB100 or SCB200 controls are used, contact the factory for troubleshooting assistance. Screen will not operate or will not go (a) Incorrect line voltage. (a) Verify 115-125V (or 220-240V). If “down”.
Page 9
TROUBLESHOOTING SYMPTOM CAUSE SOLUTION Door will not open. (a) Hinge is bound or has a foreign (a) Check installation to free door. Clear substance on it which does not allow any foreign substance; i.e., paint or it to open by gravity. plaster from hinge.