Important Safety Instructions; Pre-Installation; Case Installation - Da-Lite Tensioned Advantage Electrol Instruction Book

When using your video equipment, basic safety precautions should always be followed, including the
following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance
should be used. Cords rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized
service dealer when repair work is required. Incorrect reassembly can cause electric shock when
the appliance is used subsequently.
5. The use of an accessory attachment not recommended by the manufacturer may cause a risk of
fire, electric shock, or injury to persons.

PRE-INSTALLATION

1. Carefully unpack case from shipping carton. DO NOT unpack fabric and roller assembly yet.
2. Make sure to recheck measurement of case for proper installation clearance.
3. Remove any protective foam or tape from case.

CASE INSTALLATION

1. Remove 2 screws to open junction box (Fig. 1).
2. Hang case and attach to support structure with threaded rod. See suggested methods of installation on page 4.
3. Tighten bolts until trim flange is flush with ceiling.
NOTE: For proper operation, screen assembly must be level after installation.
4. Install electrical connections that applies to your unit. Make sure to review the wiring diagram for proper hook up.
5. Replace junciton box cover and secure with 2 screws.
SCREEN AND ROLLER ASSEMBLY INSTALLATION
1. Remove access door. First, remove the 2 screws from the ends (Fig. 1), be sure to support the door during this
step to avoid injury. Then lift the door slightly and pull away from the edge of the case.
2. Carefully unpack screen and roller assembly. Leave packing paper on roller.
3. Next, install pin-end bracket into case by inserting at a slightly counter-clockwise angle until flush with top of case.
Then twist bracket until perpendicular with case and is locked into bracket channels.
4. To install screen and roller assembly, insert the motor end into the motor mount bracket as shown in Fig. 2. Tighten
4 set screws to secure bracket.
5. Finally, slide pin end bracket until the roller pin is seated in the bushing. Tighten 4 set screws to secure bracket.
6. Carefully remove paper and tape from roller assembly. DO NOT use a knife or sharp object to cut tape, you will
damage the screen.
7. Complete electrical hook-up by snapping motor wire connector into case connector.
8. Test installation by running screen up and down a few times. Be prepared to stop screen.
9. Re-install access door. Procedure is reverse of removal.
!
CAUTION! Excessive continuous operation may cause the motor to overheat. If this happens, the motor will shut off until it
cools to a normal operating temperature.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
1