Overdrive; Distortion; Vs Overdrive; Vs Distortion - Roland JUNO-Di Editor Owner's Manual

35:

OVERDRIVE

Creates a soft distortion similar to that produced by vacuum tube
amplifiers.
fig.MFX-35
L in
Over
drive Simulator
R in
Parameter Value
Drive # 0–127
SMALL, BUILT-IN,
Amp Type
2-STACK, 3-STACK
Low Gain
-15–+15 dB
High Gain -15–+15 dB
Pan # L64–63R
Level
0–127
36:

DISTORTION

Produces a more intense distortion than Overdrive. The parameters
are the same as for "35: OVERDRIVE."
fig.MFX-36
L in
Distortion
Simulator
R in
37:

VS OVERDRIVE

This is an overdrive that provides heavy distortion.
fig.MFX-37
L in
Overdrive
Simulator
R in
Parameter Value
Drive # 0–127
Tone # 0–127
Amp Sw OFF, ON
SMALL, BUILT-IN,
Amp Type
2-STACK, 3-STACK
Low Gain -15–+15 dB
High Gain -15–+15 dB
Pan # L64–63R
Level
0–127
Pan L
Amp 2-Band
EQ
Pan R
Explanation
Degree of distortion
Also changes the volume.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack
amp
3-STACK: large triple stack
amp
Gain of the low range
Gain of the high range
Stereo location of the output
sound
Output Level
Pan L
Amp 2-Band
EQ
Pan R
Pan L
Amp 2-Band
EQ
Pan R
Explanation
Degree of distortion
Also changes the volume.
Sound quality of the Overdrive effect
Turns the Amp Simulator on/off.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Gain of the low range
Gain of the high range
Stereo location of the output sound
Output Level
38:

VS DISTORTION

This is a distortion effect that provides heavy distortion. The
parameters are the same as for "37: VS OVERDRIVE."
fig.MFX-38
L in
L out
R in
R out
39:

GUITAR AMP SIMULATOR

This is an effect that simulates the sound of a guitar amplifier.
fig.MFX-39
L in
R in
Parameter
Pre Amp Sw
Pre Amp Type
L out Pre Amp
Volume #
Pre Amp
Master #
R out
Pre Amp Gain
Pre Amp Bass
Pre Amp
Middle
Pre Amp Treble
Pre Amp
Presence
L out
Pre Amp Bright OFF, ON
R out
Speaker Sw
Speaker Type
Mic Setting
Mic Level
Direct Level
Pan #
Level #
Amp 2-Band
Distortion
Simulator
Pre Amp
Speaker
Value Explanation
OFF, ON Turns the amp switch on/off.
JC-120,
CLEAN TWIN,
MATCH DRIVE,
BG LEAD, MS1959I,
MS1959II, MS1959I+II,
SLDN LEAD, Type of guitar amp
METAL 5150,
METAL LEAD,
OD-1,
OD-2 TURBO,
DISTORTION, FUZZ
Volume and amount of distortion
0–127
of the amp
0–127 Volume of the entire pre-amp
LOW, MIDDLE, HIGH Amount of pre-amp distortion
Tone of the bass/mid/treble
frequency range
0–127
* Middle cannot be set if
"MATCH DRIVE" is selected as
the Pre Amp Type.
Tone for the ultra-high frequency
0–127
range
Turning this "On" produces a
sharper and brighter sound.
* This parameter applies to the
"JC-120," "CLEAN TWIN,"
and "BG LEAD" Pre Amp
Types.
Determines whether the signal
OFF, ON passes through the speaker (ON),
or not (OFF).
(See the table below.) Type of speaker
Adjusts the location of the mic that's
capturing the sound of the speaker.
This can be adjusted in three
1, 2, 3
steps, from 1 to 3, with the mic
becoming more distant as the
value increases.
0–127 Volume of the mic
0–127 Volume of the direct sound
L64–63R Stereo location of the output
0–127 Output level
Effects List
L out
Pan L
EQ
Pan R
R out
L out
Pan L
Pan R
R out
77