Patch Effects; Signal Flow And Parameters (Routing) - Roland JUNO-Di Editor Owner's Manual

PATCH EFFECTS

In Patch mode you can use one multi-effect (MFX), one chorus, and one reverb.

Signal Flow and Parameters (ROUTING)

Here you can make overall settings for effects, such as the output destination and level of the various signals.
Parameter Range
TONE SELECT
1–4
(KEY NAME) (A0–C8)
MFX,
PATCH OUTPUT
L+R,
ASSIGN
L,
(RHYTHM OUTPUT
R,
ASSIGN)
TONE
MFX,
TONE OUTPUT L+R,
ASSIGN
L,
R
TONE OUTPUT
0–127
LEVEL
TONE CHORUS
0–127
SEND LEVEL
TONE REVERB
0–127
SEND LEVEL
MFX (Type) 0–79
MFX OUTPUT LEVEL
0–127
MFX CHORUS SEND
0–127
LEVEL
MFX REVERB SEND
0–127
LEVEL
OFF,
CHORUS (Type)
CHORUS, DELAY,
GM2 CHORUS
CHORUS LEVEL 0–127
CHORUS OUTPUT
MAIN,
SELECT MAIN+REV, REV
Explanation
The tone (rhythm tone) to edit
If you've selected a rhythm set, this will be KEY NAME.
Specifies how the unprocessed sound of the patch (rhythm set) will be output
If you've selected a rhythm set, this will be RHYTHM OUTPUT ASSIGN.
MFX: Output in stereo via the multi-effect. Chorus and reverb can also be applied after the multi-
effect.
L+R: Output in stereo from the OUTPUT jacks without passing through the multi-effect
L: Output in mono from the OUTPUT L jack without passing through the multi-effect
R: Output in mono from the OUTPUT R jack without passing through the multi-effect
TONE: Output according to the settings of each tone
Specifies how the unprocessed sound of each tone will be output
MFX: Output in stereo via the multi-effect. Chorus and reverb can also be applied after the multi-
effect.
L+R: Output in stereo from the OUTPUT jacks without passing through the multi-effect
L: Output in mono from the OUTPUT L jack without passing through the multi-effect
R: Output in mono from the OUTPUT R jack without passing through the multi-effect
* The setting you specify here is valid only if PATCH OUTPUT ASSIGN is set to "TONE."
* If STRUCTURE (p. 30) is set to TYPE 02–10, the settings for tone 1 (3) will follow the settings of
tone 2 (4). (This is because the outputs of tones 1 and 2 are combined into tone 2, and the outputs
of tones 3 and 4 are combined into tone 4.)
Level of signal sent from each tone to the destination specified by OUTPUT ASSIGN
Level of signal sent from each tone to the chorus
Level of signal sent from each tone to the reverb
Type of multi-effect to use (choose one of 79 types)
For details on each multi-effect, refer to "Multi-Effects Parameters (MFX1–3, MFX)" (p. 64).
Volume of the sound that has been processed by the multi-effect
Amount of chorus applied to the sound that has been processed by the multi-effect
Amount of reverb applied to the sound that has been processed by the multi-effect
Type of chorus
OFF: Chorus/delay will not be used
CHORUS: Chorus
DELAY: Delay
GM2 CHORUS: GM2 chorus
Volume of the sound that has been processed by the chorus
Output destination of the sound that has been processed by the chorus
MAIN: Output in stereo to the OUTPUT jacks
MAIN+REV: Output in stereo to the OUTPUT jacks and in mono to the reverb
REV: Output in mono to reverb
EFFECTS Parameters
17