Roland JUNO-Di Editor Owner's Manual page 38

Detailed Editing for a Patch (PATCH Parameters)
AMP ENV (TVA ENVELOPE)
Parameter Value
TIME KF
-100–+100
(TIME Keyfollow)
T1 SENS -63–+63
T4 SENS -63–+63
T1–4 ★
0–127
(Time 1–4)
L1–3
0–127
(Level 1–3)
TVA Envelope
T1 T2 T3
Level
L3
L1 L2
Note on
OUTPUT
Parameter Value
SEND LEVEL OUT
0–127
(Output Level)
SEND LEVEL (OUTPUT ASSIGN = MFX)
CHO (Chorus Send) 0–127
REV (Reverb Send)
0–127
SEND LEVEL (OUTPUT ASSIGN = non MFX)
CHO (Chorus Send) 0–127
REV (Reverb Send)
0–127
MFX,
OUTPUT ASSIGN L+R,
L, R
38
Parameter marked with a "★" can be controlled using specified MIDI messages.
Explanation
Use this setting if you want the TVA envelope times (T2–T4) to be affected by the keyboard location.
Based on the TVA envelope times for the C4 key (center C), positive (+) settings will cause notes higher
than C4 to have increasingly shorter times, and negative (-) settings will cause them to have
increasingly longer times. Larger settings will produce greater change.
This allows keyboard dynamics to affect the T1 of the TVA envelope.
If you want Time 1 to be speeded up for strongly played notes, set this parameter to a positive (+)
value. If you want it to be slowed down, set this to a negative (-) value.
Use this parameter when you want key release speed to affect the T4 value of the TVA envelope.
If you want T4 to be speeded up for quickly released notes, set this parameter to a positive (+) value.
If you want it to be slowed down, set this to a negative (-) value.
TVA envelope times (T1–T4)
Higher settings will lengthen the time until the next volume level is reached.
TVA envelope levels (L1–L3)
Specify how the volume will change at each point, relative to the LEVEL value.
Time
T4
Time
Note off
C1
Explanation
Level of the signal that is sent to the output destination specified by OUTPUT ASSIGN
Level of the signal sent to chorus for each tone if the tone is sent through MFX
Level of the signal sent to reverb for each tone if the tone is sent through MFX
Level of the signal sent to chorus for each tone if the tone is not sent through MFX
Level of the signal sent to reverb for each tone if the tone is not sent through MFX
Specifies how the direct sound of each tone will be output.
MFX: Output in stereo through multi-effects. You can also apply chorus or reverb to the sound that passes
through multi-effects.
L+R: Output in stereo to the OUTPUT jacks without passing through the multi-effect
L: Output in mono to the OUTPUT L jack without passing through the multi-effect
R: Output in mono to the OUTPUT R jack without passing through the multi-effect
* If the PATCH OUTPUT ASSIGN is set to anything other than "TONE," these settings will be ignored.
* If "STRUCTURE" (p. 30) is set to TYPE 02–10, the settings for tone 1 (3) will follow the settings of tone
2 (4). (This is because the outputs of tones 1 and 2 are combined into tone 2, and the outputs of tones
3 and 4 are combined into tone 4.)
* Sounds are output to chorus and reverb in mono at all times.
* The output destination of the signal after passing through the chorus is set with the CHORUS OUTPUT
SELECT (p. 17).
Time Keyfollow
C2 C3 C4 C5 C6 C7
(Matrix Control, p. 42)
-100
-50
0
+50
+100
Key