Roland JUNO-Di Editor Owner's Manual page 27

Parameter
CUTOFF ★
(Cutoff Frequency)
RES ★
(Resonance)
FILTER ENV DEPTH
(Filter Envelope Depth)
FILTER ENV A
(Filter Envelope Attack)
FILTER ENV D
(Filter Envelope Decay)
FILTER ENV S
(Filter Envelope Sustain)
FILTER ENV R
(Filter Envelope Release)
TVA
Parameter
LEVEL ★
PAN ★
AMP ENV A
(Amp Envelope Attack)
AMP ENV D
(Amp Envelope Decay)
AMP ENV S
(Amp Envelope Sustain)
AMP ENV R
(Amp Envelope Release)
SEND LEVEL OUT
(Output Level)
SEND LEVEL (OUTPUT ASSIGN = MFX)
CHO (Chorus Send)
REV (Reverb Send)
SEND LEVEL (OUTPUT ASSIGN = non MFX)
CHO (Chorus Send)
REV (Reverb Send)
Value Explanation
0–127 Frequency at which the filter begins to have an effect on the waveform's frequency components
Emphasizes the portion of the sound in the region of the cutoff frequency, adding character to the
sound
0–127
* Excessively high settings can produce oscillation, causing the sound to distort.
Depth of the TVF envelope
-63–+63
Higher settings will cause the TVF envelope to produce greater change. Negative (-) settings will
invert the shape of the envelope.
TVF envelope times
0–127 Higher settings will lengthen the time until the next cutoff frequency level is reached.
This will modify ENV T1 (p. 36).
TVF envelope times
0–127
This will modify ENV T3 (p. 36).
TVF envelope levels
0–127
Specify how the cutoff frequency will change at each point, relative to the Cutoff Frequency value.
This will modify ENV L3 (p. 36).
TVF envelope times
0–127
This will modify ENV T4 (p. 36).
Value Explanation
Volume of the tone
0–127
This setting is useful primarily for adjusting the volume balance between tones.
L64–0–63R Left/right position of the tone
TVA envelope times
0–127 Higher settings will lengthen the time until the next volume level is reached.
This will modify ENV T1 (p. 38).
TVA envelope times
0–127
This will modify ENV T3 (p. 38).
TVA envelope levels
0–127 Specify how the volume will change at each point, relative to the LEVEL value.
This will modify ENV L3 (p. 38).
TVA envelope times
0–127
This will modify ENV T4 (p. 38).
0–127 Level of the signal that is sent to the output destination specified by OUTPUT ASSIGN (p. 38)
0–127 Level of the signal sent to chorus for each tone if the tone is sent through MFX
0–127 Level of the signal sent to reverb for each tone if the tone is sent through MFX
0–127 Level of the signal sent to chorus for each tone if the tone is not sent through MFX
0–127 Level of the signal sent to reverb for each tone if the tone is not sent through MFX
Detailed Editing for a Patch (PATCH Parameters)
27