Equalizer; Spectrum; Isolator; Low Boost - Roland JUNO-Di Editor Owner's Manual

Effects List
01:

EQUALIZER

This is a four-band stereo equalizer (low, mid x 2, high).
fig.MFX-01
L in
4-Band EQ
R in
4-Band EQ
Parameter Value
Low Freq 200, 400 Hz
Low Gain # -15–+15 dB
Mid1 Freq 200–8000 Hz
Mid1 Gain
-15–+15 dB
Mid1 Q 0.5, 1.0, 2.0, 4.0, 8.0
Mid2 Freq 200–8000 Hz
Mid2 Gain -15–+15 dB
Mid2 Q 0.5, 1.0, 2.0, 4.0, 8.0
High Freq 2000, 4000, 8000 Hz
High Gain # -15–+15 dB
Level #
0–127
02:

SPECTRUM

This is a stereo spectrum. Spectrum is a type of filter which modifies
the timbre by boosting or cutting the level at specific frequencies.
fig.MFX-02
L in Spectrum
R in
Spectrum
Parameter Value
Band1 (250Hz)
Band2 (500Hz)
Band3 (1000Hz)
Band4 (1250Hz)
-15–+15 dB
Band5 (2000Hz)
Band6 (3150Hz)
Band7 (4000Hz)
Band8 (8000Hz)
0.5, 1.0, 2.0, 4.0,
Q
8.0
Level # 0–127
66
L out
R out
Explanation
Frequency of the low range
Gain of the low range
Frequency of the middle range 1
Gain of the middle range 1
Width of the middle range 1
Set a higher value for Q to
narrow the range to be
affected.
Frequency of the middle range 2
Gain of the middle range 2
Width of the middle range 2
Set a higher value for Q to
narrow the range to be
affected.
Frequency of the high range
Gain of the high range
Output Level
L out
R out
Explanation
Gain of each frequency band
Simultaneously adjusts the width of
the adjusted ranges for all the
frequency bands.
Output Level
03:

ISOLATOR

This is an equalizer which cuts the volume greatly, allowing you to
add a special effect to the sound by cutting the volume in varying
ranges.
fig.MFX-03
L in
Isolator

Low Boost

R in
Isolator
Parameter Value
Boost/
Cut Low #
Boost/
-60–+4 dB
Cut Mid #
Boost/
Cut High #
Anti Phase Low
OFF, ON
Sw
Anti Phase Low
0–127
Level
Anti Phase Mid
OFF, ON
Sw
Anti Phase Mid
0–127
Level
Low Boost Sw OFF, ON
Low Boost Level 0–127
Level 0–127
04: LOW BOOST
Boosts the volume of the lower range, creating powerful lows.
fig.MFX-04
L in
Low Boost 2-Band EQ
R in
Low Boost
2-Band EQ
Parameter Value
Boost
50–125 Hz
Frequency #
Boost Gain # 0–+12 dB
WIDE, MID,
Boost Width
NARROW
Low Gain
-15–+15 dB
High Gain -15–+15 dB
Level 0–127
L out
R out
Low Boost
Explanation
These boost and cut each of the High,
Middle, and Low frequency ranges.
At -60 dB, the sound becomes
inaudible. 0 dB is equivalent to the
input level of the sound.
Turns the Anti-Phase function on and off
for the Low frequency ranges.
When turned on, the counter-channel
of stereo sound is inverted and added
to the signal.
Adjusts the level settings for the Low
frequency ranges.
Adjusting this level for certain
frequencies allows you to lend
emphasis to specific parts. (This is
effective only for stereo source.)
Settings of the Anti-Phase function for the
Middle frequency ranges
The parameters are the same as for
the Low frequency ranges.
Turns Low Booster on/off.
This emphasizes the bottom to create
a heavy bass sound.
Increasing this value gives you a heavier
low end.
* Depending on the Isolator and filter
settings this effect may be hard to dis-
tinguish.
Output Level
L out
R out
Explanation
Center frequency at which the lower
range will be boosted
Amount by which the lower range will
be boosted
Width of the lower range that will be
boosted
Gain of the low frequency range
Gain of the high frequency range
Output level