Roland JUNO-Di Editor Owner's Manual page 49

TVA
Parameter
LEVEL
PAN
AMP ENV A
(Amp Envelope Attack)
AMP ENV D
(Amp Envelope Decay)
AMP ENV S
(Amp Envelope Sustain)
AMP ENV R
(Amp Envelope Release)
SEND LEVEL OUT
(Output Level)
SEND LEVEL (OUTPUT ASSIGN = MFX)
CHO (Chorus Send)
REV (Reverb Send)
SEND LEVEL (OUTPUT ASSIGN = non MFX)
CHO (Chorus Send)
REV (Reverb Send)
OUTPUT ASSIGN
Detailed Editing for a Rhythm Set (RHYTHM Parameters)
Value Explanation
Volume of the rhythm tone
0–127
This setting is useful primarily for adjusting the volume balance between rhythm ones.
L64–0–63R Left/right position of the rhythm tone
TVA envelope times
0–127 Higher settings will lengthen the time until the next volume level is reached.
This will modify ENV T1 (p. 55).
TVA envelope times
0–127
This will modify ENV T3 (p. 55).
TVA envelope levels
0–127 Specify how the volume will change at each point, relative to the LEVEL value.
This will modify ENV L3 (p. 55).
TVA envelope times
0–127
This will modify ENV T4 (p. 55).
0–127 Level of the signal that is sent to the output destination specified by OUTPUT ASSIGN
0–127 Level of the signal sent to chorus for each rhythm tone if the tone is sent through MFX
0–127 Level of the signal sent to reverb for each rhythm tone if the tone is sent through MFX
0–127 Level of the signal sent to chorus for each rhythm tone if the tone is not sent through MFX
0–127 Level of the signal sent to reverb for each rhythm tone if the tone is not sent through MFX
Specifies how the direct sound of each rhythm tone will be output.
MFX: Output in stereo through multi-effects. You can also apply chorus or reverb to the sound
that passes through multi-effects.
L+R: Output in stereo to the OUTPUT jacks without passing through the multi-effect
L: Output in mono to the OUTPUT L jack without passing through the multi-effect
MFX,
R: Output in mono to the OUTPUT R jack without passing through the multi-effect
L+R,
L, R
* If the OUTPUT ASSIGN in "RHYTHM COMMON" is set to anything other than "TONE," these
settings will be ignored.
* Sounds are output to chorus and reverb in mono at all times.
* The output destination of the signal after passing through the chorus is set with the CHORUS
OUTPUT SELECT parameters (p. 17).
49