Rhythm Parameters; Summary - Roland JUNO-Di Editor Owner's Manual

Detailed Editing for a Rhythm Set (RHYTHM Parameters)

RHYTHM Parameters

SUMMARY

SYSTEM COMMON
Parameter
MASTER LEVEL
PATCH RX/TX CH
(Patch Rx/Tx Channel)
RHYTHM COMMON
Parameter
LEVEL
OUTPUT ASSIGN
RHYTHM CONTROL
Parameter
PITCH BEND RANGE
MUTE GROUP
ASSIGN TYPE
ENV MODE
ONESHOT MODE
RCV EXP.
(Receive Expression)
RCV HOLD-1
(Receive Hold-1)
46
Value Explanation
0–127 Volume of the entire JUNO-Di
1–16 Channel used to transmit and receive MIDI messages for the Keyboard part in Patch mode
Value Explanation
0–127 Volume of the rhythm set
Specifies how the unprocessed sound of the patch (rhythm set) will be output
MFX: Output in stereo via the multi-effect. Chorus and reverb can also be applied after the
MFX,
multi-effect.
L+R,
L+R: Output in stereo from the OUTPUT jacks without passing through the multi-effect
L,
R, L: Output in mono from the OUTPUT L jack without passing through the multi-effect
TONE
R: Output in mono from the OUTPUT R jack without passing through the multi-effect
TONE: Output according to the settings of each tone
Value Explanation
Amount of pitch change in semitones (4 octaves) that will occur when the Pitch Bend Lever is moved
0–48
The amount of change when the lever is tilted is set to the same value for both left and right
sides.
The Mute Group function allows you to designate two or more rhythm tones that are not allowed
to sound simultaneously.
On an actual acoustic drum set, an open hi-hat and a closed hi-hat sound can never occur
OFF, 1–31
simultaneously. To reproduce the reality of this situation, you can set up a Mute Group. Up to
31 Mute Groups can be used. rhythm tones that are not belong to any such group should be
set to "OFF."
Sets the way sounds are played when the same key is pressed a number of times.
SINGLE: Only one sound can be played at a time when the same key is pressed. With
continuous sounds where the sound plays for an extended time, the previous sound is stopped
SINGLE, MULTI
when the following sound is played.
MULTI: Layer the sound of the same keys. Even with continuous sounds where the sound plays
for an extended time, such as with crash cymbals, the sounds are layered, without previously
played sounds being eliminated.
When a loop waveform (p. 45) is selected, the sound will normally continue as long as the key is
pressed. If you want the sound to decay naturally even if the key remains pressed, set this to "NO-SUS."
NO-SUS,
SUSTAIN
* If a one-shot type wave (p. 45) is selected, it will not sustain even if this parameter is set to
"SUSTAIN."
ON: The sound will play back until the end of the waveform (or the end of the envelope, whichever
OFF, ON
comes first).
OFF, ON For each rhythm tone, specify whether MIDI Expression messages will be received (ON), or not (OFF).
For each rhythm tone, specify whether MIDI Hold-1 messages will be received (ON), or not (OFF).
OFF, ON
* If "NO-SUS" is selected for ENV MODE parameter, this setting will have no effect.