Roland JUNO-Di Editor Owner's Manual page 36

Detailed Editing for a Patch (PATCH Parameters)
Parameter
VEL CURVE
(Cutoff Velocity Curve)
VEL SENS
(Cutoff Velocity Sens)
FILTER ENV (TVF ENVELOPE)
Parameter Value
DEPTH -63–+63
TIME KF
-100–+100
(Time Keyfollow)
VEL CURVE
FIX, 1–7
(Velocity Curve)
VEL SENS
-63–+63
(Velocity Sens)
T1 SENS -63–+63
T4 SENS -63–+63
T1–4 ★
0–127
(Time 1–4)
L0–4
0–127
(Level 0–4)
TVF Envelope
T1 T2
Cutoff
Frequency
L0
L1
Note on
36
Value Explanation
Curve that determines how keyboard playing dynamics (velocity) will affect the cutoff
frequency
Set this to "FIX" if you don't want the Cutoff frequency to be affected by the keyboard
velocity.
FIX, 1–7
Use this parameter when changing the cutoff frequency to be applied as a result of changes in
playing velocity.
-63–+63
If you want strongly played notes to raise the cutoff frequency, set this parameter to positive
(+) settings.
Explanation
Depth of the TVF envelope
Higher settings will cause the TVF envelope to produce greater change. Negative (-) settings will invert
the shape of the envelope.
Use this setting if you want the TVF envelope times (T2–T4) to be affected by the keyboard location.
Based on the TVF envelope times for the C4 key (center C), positive (+) settings will cause notes higher
than C4 to have increasingly shorter times.
Curve that determines how keyboard playing dynamics (velocity) will affect the TVF envelope
Set this to "FIX" if you don't want the TVF Envelope to be affected by the keyboard velocity.
1
Specifies how keyboard playing dynamics will affect the depth of the TVF envelope.
Positive (+) settings will cause the TVF envelope to have a greater effect for strongly played notes, and
negative (-) settings will cause the effect to be less.
This allows keyboard dynamics to affect the T1 of the TVF envelope.
If you want T1 to be speeded up for strongly played notes, set this parameter to a positive (+) value.
Use this parameter when you want key release speed to affect the T4 value of the TVF envelope.
If you want T4 to be speeded up for quickly released notes, set this parameter to a positive (+) value.
TVF envelope times (T1–T4)
Higher settings will lengthen the time until the next cutoff frequency level is reached.
TVF envelope levels (L0–L4)
Specify how the cutoff frequency will change at each point, relative to the Cutoff Frequency value.
T3 T4
L2 L3 L4
Note off
1 2 3
Parameter marked with a "★" can be controlled using specified MIDI messages.
2 3 4
Time
Time
C1 C2
4 5 6
5 6 7
Time Keyfollow
C3 C4 C5 C6
7
(Matrix Control, )
p. 42
-100
-50
0
+50
+100
Key
C7