Roland JUNO-Di Editor Owner's Manual page 59

MIXER
Parameter
PART 1–16
SOLO
MUTE
CATEGORY
PREV
(Preview)
CHORUS
(Chorus Send Level)
REVERB
(Reverb Send Level)
OUTPUT
(Part Output Assign)
MFX
(Part Output MFX Select)
LEVEL
(Part Output Level)
PAN
LEVEL
MASTER * These settings are SYSTEM parameters (p. 14)
CONTROL CHANNEL
MFX 1–3
MASTER LEVEL
Detailed Editing for a Performance (PERFORM Parameters)
Value Explanation
OFF, ON Switch this to ON if you want to hear the part by itself.
Mutes or un-mutes (OFF) each part.
Use this setting when, for example, you want to use the instrument for karaoke by muting
the part playing the melody, or when you want to play something using a separate sound
OFF, ON
module.
* The MUTE parameter does not turn the part off, but sets the volume to minimum so that no
sound is heard. Therefore, MIDI messages are still received.
Type (category) of the patch
—
* "NO ASSIGN" can't be selected on the JUNO-Di itself.
OFF, ON If you switch this to ON, you'll be able to hear a preview sound played by that patch.
0–127 Level of the signal sent to chorus for each part
0–127 Level of the signal sent to reverb for each part
Specifies for each part how the direct sound will be output.
MFX: Output in stereo through multi-effects. You can also apply chorus or reverb to the
sound that passes through multi-effects.
L+R: Output in stereo to the OUTPUT jacks without passing through the multi-effect
MFX,
L: Output in mono to the OUTPUT L jack without passing through the multi-effect
L+R,
R: Output in mono to the OUTPUT R jack without passing through the multi-effect
L, R,
PAT: The part's output destination is determined by the settings of the patch or rhythm set
PAT
assigned to the part.
• Chorus and reverb are output in mono at all times.
• The output destination of the signal after passing through the chorus is set with the
CHORUS OUTPUT SELECT parameters (p. 17).
1–3 Multi-effect used by the part (choose one of MFX 1–3)
0–127 Level of the signal that is sent to the output destination specified by OUTPUT.
L64–0–63R Left/right position of each part
Volume of each part
0–127
This setting's main purpose is to adjust the volume balance between parts.
Specify the reception channel that will be used when using MFX control to control the multi-
effect parameter in real time, when MFX 1–3 SOURCE (p. 20) is set to "PERFORM."
1–16, OFF
Leave this "OFF" if you're not using MFX control.
* This parameter is not available in Patch mode.
0–127 Volume of the entire JUNO-Di
59