Set Mode; I Entering Set Mode; I Set Mode Items - Icom IC-M45EURO Instruction Manual

I Entering SET mode

SET mode is used to customize operation of the transceiver
to suit your operating needs.
D To enter SET mode:
➀
While pushing [16], turn power ON.
• Keep pushing [16] until the initial SET mode display appears.
• SET mode is selected.
➁
To exit SET mode, turn power OFF then ON again.
D To select an item:
There are 5 items in SET mode that may be adjusted to suit
your operating needs.
➀
Select SET mode as above.
➁
Push [16] to select an item; then push [UP]/[DN] to set the
condition for the item.

SET MODE

I SET mode items

*
*
Select a
SET mode *
2
item*
*
SET mode items above are shown at their
default conditions.
4
Beep tones (p. 12)
1
2
*
Normal/priority
1
2
*
scan (p. 12)
Scan timer (p. 12)
1
2
*
Dual/tri-watch (p. 12)
1
2
*
Select a
SET mode
1
condition*
11