Table of Contents
Advertisement
I Scan function
The transceiver has a high speed scan function for standing
by on utility signals. The scan speed is 8 channel/sec. (ex-
cept when the weather alert function is in use).
Two scan types are available:
channels in sequence) and priority scan (checks channel 16
while scanning). These scans can be selected in SET mode
(p. 12).
D Setting tag channels
You can specify channels as tag channels for efficient scan-
ning. Tag channels can be set for each channel group (USA,
INT) independently.
➥ Select the desired channel, then push [
sec. to toggle the tag setting.
Appears when the channel is
TAG
specified as a tag channel.
USA
✔ Clearing all tag channels
While pushing [H/L], push [
SCAN
long beep becomes 2 short beeps.
• All tag channels in the selected channel group are released.
normal scan (scans all tag
• TAG] for 1
SCAN
• TAG] for 3 sec. until the
D Scan operation
➀
Be sure the squelch is set to the threshold point.
➁
Push [SCAN] to start scanning.
• "SCAN" appears and flashes in the function display.
• "16" appears during priority scan.
➂
To stop the scan, push [SCAN] again.
• "SCAN" disappears.
✔ Scan resume timer
When a signal is detected, scan pauses until the signal dis-
appears or resumes after pausing 5 sec., according to the
SET mode setting. (p. 12)
✔ Confirming tag channels
While operating scan, push [UP] or [DN].
• Only tag channels are selected.
• Stop pushing [UP] or [DN] to resume scan.
3
BASIC OPERATION
9
Advertisement
Table of Contents
