What To Do If - AEG EE4003011 User Manual

24

What to do if...

2. Fully press clamping levers (A) on the
two door hinges.
3. Close the oven door until the first posi-
tion (angle approximately 70°).
4. Hold of the oven door with one hand on
each side and pull it away from the oven
at an up angle.
To install the door follow the procedure in re-
verse.
The number of glass panels if different for the different models.
CAUTION!
Put the oven door with the outer side down on a soft and level surface to prevent scratches.
Removing and cleaning the door glass panels
1. Remove the oven door.
2. Hold the door t (B) on the top edge of
the door at the two sides and push in-
wards to release the clip seal.
3. Pull the door t to the front to remove it.
4. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.
WHAT TO DO IF...
WARNING!
Refer to "Safety information" chapter.
Problem
The cooking zone do not oper-
ate
Possible cause
Consult the operating instructions for the built-in cooking sur-
face
A
B
Remedy
A